Logo

DF116 Engine Trouble Code

Meaning of DF116 engine trouble code is a kind of and DF116 if your catalytic convertor fails completely, you eventually won't be able to keep the car running. Your gas mileage will also be terrible, so you should try and fix it as soon as you can. Unfortunately, the average replacement cost is around $2,140 and you can't do it yourself unless you're an experienced mechanic.

DF116 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for DF116 code is occuring now you should check DF116 repair processes.
Now don't ask yourself; What should you do with DF116 code ?
The solution is here :

DF116 Possible Solution:

DF116 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

DF116 Code Meaning :

D f 1 1 6
For Engine Fuel Rail/System Pressure - Too High Engine Shutoff Solenoid Malfunction Ignition Coil A Primary/Secondary Circuit Malfunction

The catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate.

DF116 Description

DF116 engine trouble code is about Ignition Coil A Primary/Secondary Circuit Malfunction.

Main reason For DF116 Code

The reason of DF116 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

DF116 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.